Introducing Waterless Masonry Cleaner

6/8/2016 (Permalink)

Before and after of brick work that hard to reach deep down dirt and grime imbedded into the stone.

SERVPRO asked ENVIRO-SHIELD answered. Introducing a new product formulated with natural rubber that is intended to remove heavy dirt, grime, soot, nicotine and stains on limestone, sandstone, marble, concrete, plaster, brick and terra cotta. Designed for both interior and exterior use, its waterless application makes it a very safe, effective, acid free solution that can be used virtually anywhere without making a mess. It was specifically formulated to work below the surface and pull out ugly stains that penetrated deep into the pores of most  masonry materials.

• No water required

• Brush on spray application

• Effective on smoke, dirt, soot, nicotine and more

• Environmentally friendly

• Spray on, let dry and peel off

• Acid-Free/ Water Based

• Zero VOC

ENVIRO-SHIELD Masonry Cleaner

This products is engineered for airless spray or brush application. By applying a thick even layer of Enviro-Shield masonry cleaner to the affected surface it will peel easily off once it has had a chance to dry. Once it has been applied it is left alone for 24-36 hours depending on the temperature. When it starts to turn a shade of yellow and becomes rubbery to the touch it is ready to be removed. One important point is that it can not be applied to exterior surfaces if the temperature will be over 90 degrees or it is raining out.